Grimmspeed Mazdaspeed Electronic Boost Controller Instrukcja Użytkownika Strona 1

Grimmspeed 1 GrimmSpeed 3 Port Boost Control Solenoid Installation Instructions MazdaSpeed3/MazdaSpeed6 ***Picture above is MS6 BCS*** All GrimmSpe

Grimmspeed 10 1. You will be installing the GrimmSpeed solenoid on the firewall above the turbo. You will be using the existing two factory studs.

Grimmspeed 11 Please contact us if you have any questions during installation. 612.379.0000 or [email protected]. Thank you for y

Grimmspeed 2 A. Purpose The benefits of this upgrade are faster spool, ability to hold higher boost, and better control over boost. A side benefit of

Grimmspeed 3 D. 2-Port Installation Installation for MazdaSpeed3: 1. Remove air box top. 2. Remove top battery cover. 3. Remove front battery c

Grimmspeed 4 4. Line up the left grommet hole with the existing front battery cover hole near the top of the cover. The bracket grommets should be p

Grimmspeed 5 7. Disconnect brake booster vacuum line for easy access to solenoid. 8. Locate the factory boost control solenoid that is bolted to th

Grimmspeed 6 10. Hook up vacuum lines. Port 1 on the GrimmSpeed BCS will connect to a high pressure boost source. Connect the 4mm (smaller) vacuum li

Grimmspeed 7 Figure: Installation diagram for 2-port bleed mode setup. 12. In bleed mode, you will only be utilizing two of the three ports on the BC

Grimmspeed 8 A 3-port solenoid does away with the bleed-based system, explicitly shunting air from the compressor to the wastegate, or compressor to v

Grimmspeed 9 11. Port 2 connects to the internal wastegate actuator vacuum nipple. Remove oem hose on top of actuator and replace with 4mm hose and b